What To Do When A Baby Chokes On Phlegm

Performance - Maintenance - solution

had my swallow for maintenance in the workshop Simson.
I had until now always quite a loss of power, against the wind, or if it went up the mountain. Had to constantly switch back and had zero torque at low engine speeds. What has also had a very negative effect on fuel consumption.
Now Fits everything again! Top performance! Mountains, which I'd been climbing up to 40km / h or in 2nd gear, I can do now loosely with 50km/h...SUPER!

following was done:
-New spark plug, breaker, Ignition capacitor, ignition cables
-new gasket for sealing cap (under flywheel)
-new oil seal 17x28x07 (under flywheel)
-slide stop screw f. BVF16N-1
And of course, set ignition, compression checked.

is now all fit for our Triple-MMM-tour!

Impétigo Herpes Difference

coloring hair


deal In this tutorial we are with this pretty Pin-Up Girl and their hair color .
you will see how you can change later in only 4 steps every hair color - with no tint or Cremecoloration!

step 1: We work in Maskiermodus 'Q' and we take the brush tool 'B' for help.


Choose a brush tip allows you to mask out the hair of our cover girls easily. It does not matter, imagine the hair very accurate - the subtleties we take care of in a later step.

After the painting we close the Maskiermodus again with 'Q' and the hair should look like this:

Step 2: Invert selection with 'Shift + Ctrl + I' and create a new layer .


step 3: Fill the new layer with any fill color (! Depending on the desired hair color you have) and change the Blending Options ...


... Right-click on the plane, we select the Blending Options and set 'Soft Light' a:

Step 4: fine-tuning with the eraser 'E'. This hair surfaces that have become too easy to erase or fill in bare spots with the brush 'B'.


And the end result should look like this:

If you do not have enough, you can use this Tutorial change also still the same eye color! hbert

image aboutpixel of

Food To Treat Anorexia

s / w desaturate image coloring

It has yet determined any such ancestral photos at home. Would not it be nice to them and coloring them as to approximate a color picture? Learn here in 16 steps how to every s / w image coloring easy and effective.

Step 1: Open 'Ctrl + O' of the image here: urahnen.jpg and create a new layer


Step 2: Coloring the plane. Click on the black swatch in the tool bar appears the 'Color Picker' (as shown).


We will choose the color from # 684B1D and ...

... select the entire image area of 'Ctrl + A'.

It appears that dashed border.

which should look after the filling of 'G' so. Setting the level with 'color' (as shown)

Then should all look like this:

The plane renamed 'Background color'

step 3.

Step 4: New level and rename the layer. We want to take care of the first place for the girl's hair.


Step 5: Set a color using the 'Fabwählers' (as in step 2), here: a friendly Blonde # F4D218.


Step 6: Brush Tool 'B' and coloring the hair. It is important that the brush is selected with a soft edge and match the hair generously imagined. (As shown) adjusting the level with 'color':


Step 7


Step 8: Set the opacity of the layer, here at about 30%.


Step 9: We will now take care of the face and clothes of the girl. In advance, we must remove the face and clothing of the girl on the plane 'background color'.

We activate the layer 'Background color' and the eraser tool 'E' and ...

... the said bodies to occur after the coloring does not remove color variations.

Step 10: The skin - Repeat steps 4 - 8, consisting of-New Layer, rename the layer, select a color and an image game, coloring, changing to 'color', set the opacity.


Step 11: The whites of eyes - Repeat steps 4 - 8, consisting of-New Layer, rename the layer, select a color and an image game, coloring, changing to 'color', set the opacity.


Step 12: The Eye - Repeat steps 4 - 8, consisting of-New Layer, rename the layer, select a color and an image game, coloring, changing to 'color', set the opacity.


Step 13: The Lips - Repeat steps 4 - 8, consisting of-New Layer, rename the layer, select a color and an image game, coloring, changing to 'color', Setting the opacity.


Step 14: The dress - Repeat steps 4 - 8, consisting of-New Layer, rename the layer, select a color image and a lot, painting, changing to 'color', set the opacity.


Step 15: The boots - Repeat steps 4 - 8, consisting of-New Layer, rename the layer, select a color and an image game, coloring, changing to 'color', set the opacity .


Step 16: The Loop - Repeat steps 4 - 8, consisting of-New Layer, rename the layer, select a color and an image game, coloring, changing to 'color', set the opacity.


So the girl looks after the coloration from.

And after coloring the whole family, the ancestors photo looks like this:
in the original image from pixelio.de of Pandi